What Heat Pump Installation Actually Costs in Georgetown
A full heat pump system, the outdoor heat pump unit paired with a matching indoor air handler, typically installs for $6,500 to $13,500 in Georgetown, with most 1,800 to 2,400 square foot homes landing between $8,000 and $10,000 for a mid-efficiency 3-ton system. The spread comes down to three things: the tonnage the load calculation calls for, the SEER2 efficiency rating chosen, and how much of the existing ductwork and electrical setup can be reused versus needs modification.
That range sits close to, but usually a notch above, a comparable straight AC and gas furnace replacement, because the heat pump's outdoor unit is doing double duty, reversing its refrigerant cycle to provide both cooling in July and heating in January instead of relying on a separate combustion furnace for the winter half of the job.
| System Size | Typical Georgetown Home | Standard SEER2 Installed | High-Efficiency SEER2 Installed |
|---|---|---|---|
| 2 Ton | Under 1,400 sq ft | $6,500 - $8,000 | $8,500 - $10,500 |
| 3 Ton | 1,800 - 2,000 sq ft | $8,000 - $10,000 | $10,500 - $12,500 |
| 4 Ton | 2,200 - 2,800 sq ft | $9,500 - $11,500 | $12,000 - $13,500 |
| 5 Ton | 2,800+ sq ft | $10,500 - $12,500 | $13,000 - $15,000 |
Figures are typical installed ranges for Georgetown TX and Williamson County; a written quote after an in-home load calculation and duct inspection is the only accurate number for a specific house.
ProAir Georgetown
Ready for a real number for your home?
Why Georgetown's Mild Winters Make Heat Pumps a Good Fit
Heat pump heating efficiency drops as the outdoor temperature falls, which is why they get a mixed reputation in genuinely cold climates. Georgetown doesn't have that problem. Winter lows here rarely sit below freezing for more than a few days at a stretch, and the coldest snaps, the kind that hit Williamson County during the February 2021 freeze, are the exception rather than the norm. For the vast majority of the heating season, a properly sized heat pump runs efficiently on its own, with a small electric heat strip kicking in only during the rare hard freeze to cover the gap.
That climate match is part of why heat pump installs have grown steadily across Sun City, Teravista, and Rancho Sienna over the past several years: homeowners get efficient cooling all summer and reasonably efficient heating all winter from one piece of outdoor equipment, instead of paying to install and maintain two separate systems, an AC condenser and a gas furnace, that each only run for part of the year.
What Changes the Quote: Ductwork, Electrical, and SEER2
Three variables move a heat pump quote more than anything else. First, ductwork condition: a heat pump moves a different airflow profile than some older AC-and-furnace setups, and undersized or leaky ducts sometimes need modification to deliver full performance, which adds cost but also avoids uneven room temperatures after installation. Second, electrical capacity: heat pump systems, particularly with backup heat strips, sometimes require more amperage than an older home's panel was built to supply, and a panel upgrade, when needed, is a real added line item worth asking about upfront. Third, SEER2 rating: a baseline-efficiency system costs less to install but more to run, while a high-efficiency system costs more upfront in exchange for lower monthly bills, and the right trade-off depends on how long the homeowner plans to stay in the house.
A straightforward swap, same tonnage, ducts in good shape, existing panel with capacity to spare, is the fastest and least expensive path. Homes in older Georgetown neighborhoods with original 1990s-era ductwork or a smaller electrical panel should expect the estimate to include an inspection line item for those systems before a final number is locked in.
Heat Pump vs. Straight AC Plus Furnace: The Real Cost Comparison
Comparing a heat pump against a straight AC paired with a gas furnace only on the installed price misses half the picture. The heat pump typically costs somewhat more to install as a single combined system, but it replaces two pieces of equipment, the AC condenser and the furnace, that would otherwise each need their own eventual repair and replacement cycle. Over a 10 to 15 year system life, many Georgetown homeowners find the heat pump's lower winter operating costs and the avoided cost of maintaining a separate furnace narrow or close the upfront cost gap, especially in a climate where the heat pump rarely has to work hard against genuinely cold outdoor air.
💲 ProAir Georgetown provides free, written heat pump installation quotes after an in-home load calculation, no square-footage guesswork. We size the system to the house, check ductwork and electrical capacity upfront, and give a firm number before any work begins. Call (512) 798-8094 or visit our Heat Pump Services page.