Georgetown Hard Water Note: Georgetown draws from the Edwards Aquifer, one of the hardest water sources in Texas. This means AC drain lines accumulate mineral scale significantly faster than in Austin or Round Rock. Annual drain cleaning is strongly recommended here.
Condensate Drain Services
Clear blocked AC drain lines with pressurized flush and vacuum, the most common summer service call in Georgetown.
Repair cracked, disconnected, or improperly pitched drain lines causing leaks or improper drainage.
Clear and flush condensate P-traps that accumulate sludge and cause drain restriction or float switch trips.
Chemical treatment of drain lines to dissolve biofilm and mineral scale buildup, recommended for Georgetown's hard water.
Drain Pans, Pumps & Safety Devices
Install properly configured P-traps to maintain the water seal required for correct drain system function.
Install float switches that shut down the system if the drain pan fills, prevents water damage from drain backups.
Install secondary drain pans under attic air handlers, required by code and essential for protecting Georgetown ceilings.
Replace cracked or rusted drain pans before they leak into ceilings or cause structural damage.
Install or repair condensate pumps for systems that can't gravity-drain, basements, closets, and attic systems without nearby drain access.
Install condensate neutralizers for high-efficiency furnaces and heat pumps that produce acidic condensate.
Emergency response for active water leaks from HVAC drain pans, stop water damage before it spreads.
Moisture Control & Water Leak Services
Comprehensive HVAC moisture management, condensate drainage, humidity control, and insulation assessment.
Full condensate drainage system evaluation and repair, drain lines, trap, pan, float switch, and pump.
Balance system moisture removal for consistent indoor humidity levels in Georgetown's humid climate.
Identify and address condensation problems on HVAC components, ductwork, and supply registers.
Preventive treatments and insulation improvements to eliminate recurring condensation issues.
Diagnose and repair all causes of water leaks from indoor air handler units, drain, coil, or housing.
Address water pooling around outdoor units, improper drainage, defrost water, or refrigerant issues.
The Georgetown TX Difference
The drain pan sits directly beneath the evaporator coil in the indoor air handler, catching every drop of condensate before it reaches the drain line. Most Georgetown homes built from the 1990s through the mid 2000s were fitted with galvanized steel pans, which corrode from the inside out once the zinc coating wears through. Newer systems typically use molded plastic or fiberglass composite pans, which do not rust but can crack from age, UV exposure through attic vents, or from being stepped on during other attic work.
A failing drain pan rarely announces itself until water is already coming through. Rust flakes in the pan, a hairline crack you can see light through, or a pan that flexes and pools water instead of draining cleanly toward the outlet are all signs the pan needs replacement rather than repair. Because the pan is load-bearing for the coil and connects to both the primary drain line and, in many installs, a float switch, replacing it means fully supporting the coil, disconnecting refrigerant lines is not required if the pan sits below the coil rack, draining and removing the old pan, then setting a correctly sized replacement with the same pitch toward the drain outlet.
Georgetown's attics regularly exceed 130 degrees Fahrenheit in July and August, and that heat cycling is hard on plastic and composite pans in particular, the material expands and contracts daily for years until it becomes brittle at the seams. Attic air handlers here also see more thermal stress than closet or garage units because the ambient temperature swing between winter mornings and summer afternoons is larger. When we replace a pan in an attic install, we also check that the secondary pan underneath the primary, where present, is intact and that its own drain line is unobstructed and terminates somewhere visible, since a secondary pan doing its job silently is easy to forget until it also fails.
Pricing for pan replacement depends on accessibility and pan material, straightforward closet or garage units typically run less than attic installs where the technician has to work in confined, hot space. As a rough range, expect somewhere between $250 and $650 depending on unit accessibility and pan type, with the service call fee determined based on the specific service needed and your service area.
Frequently Asked Questions, AC Drain Pan Replacement
AC Water Leak or Drain Backup?
Don't wait on water damage. We respond same-day for drainage emergencies.