Georgetown Hard Water Note: Georgetown draws from the Edwards Aquifer, one of the hardest water sources in Texas. This means AC drain lines accumulate mineral scale significantly faster than in Austin or Round Rock. Annual drain cleaning is strongly recommended here.
Condensate Drain Services
Clear blocked AC drain lines with pressurized flush and vacuum, the most common summer service call in Georgetown.
Repair cracked, disconnected, or improperly pitched drain lines causing leaks or improper drainage.
Clear and flush condensate P-traps that accumulate sludge and cause drain restriction or float switch trips.
Chemical treatment of drain lines to dissolve biofilm and mineral scale buildup, recommended for Georgetown's hard water.
Drain Pans, Pumps & Safety Devices
Install properly configured P-traps to maintain the water seal required for correct drain system function.
Install float switches that shut down the system if the drain pan fills, prevents water damage from drain backups.
Install secondary drain pans under attic air handlers, required by code and essential for protecting Georgetown ceilings.
Replace cracked or rusted drain pans before they leak into ceilings or cause structural damage.
Install or repair condensate pumps for systems that can't gravity-drain, basements, closets, and attic systems without nearby drain access.
Install condensate neutralizers for high-efficiency furnaces and heat pumps that produce acidic condensate.
Emergency response for active water leaks from HVAC drain pans, stop water damage before it spreads.
Moisture Control & Water Leak Services
Comprehensive HVAC moisture management, condensate drainage, humidity control, and insulation assessment.
Full condensate drainage system evaluation and repair, drain lines, trap, pan, float switch, and pump.
Balance system moisture removal for consistent indoor humidity levels in Georgetown's humid climate.
Identify and address condensation problems on HVAC components, ductwork, and supply registers.
Preventive treatments and insulation improvements to eliminate recurring condensation issues.
Diagnose and repair all causes of water leaks from indoor air handler units, drain, coil, or housing.
Address water pooling around outdoor units, improper drainage, defrost water, or refrigerant issues.
Why This Matters in Georgetown
Drain repair is a different job from drain cleaning. Cleaning clears a line that is blocked but structurally intact, repair addresses a line that is physically damaged, disconnected, or was never installed correctly in the first place. We see all three in Georgetown homes, and the fix for each is specific to what actually failed.
Cracked PVC sections usually happen at a glued joint that was never properly primed and cemented, or from a section that got knocked loose during other attic or crawlspace work, insulation replacement, wiring runs, or duct repairs nearby. A cracked joint drips slowly rather than gushing, which is why it often goes unnoticed until a stain appears on a ceiling or a musty smell develops in a closet. Flexible vinyl tubing fails differently, it disconnects at its barbed fitting connections when the tubing hardens and shrinks with age, or it develops a pinhole from rubbing against a sharp edge like ductwork strapping or a joist over months of vibration.
Improper pitch is the failure mode that is hardest to spot without a level, and the most common installation mistake we correct. Condensate lines need a consistent downward slope, generally a minimum of one quarter inch per foot of run, to keep water moving by gravity alone. A line that was installed level, or worse, with a low spot or belly partway through its run, will pool water at that low point even when nothing is technically clogged, and that standing water becomes the perfect breeding ground for the algae growth that then causes an actual clog on top of the pitch problem.
Our repair process starts with tracing the full line from the air handler to its termination point, identifying every joint, support point, and grade change along the way, since a repair that only fixes the visible crack without correcting an underlying pitch problem tends to fail again quickly. Depending on what we find, repair can mean re-cementing a PVC joint, replacing a section of flexible tubing with rigid PVC for durability, adding hangers or supports to correct sag, or re-routing a section entirely to establish proper fall toward the drain. Repairs are generally priced in a modest range depending on how much of the line needs to be replaced and how accessible the run is, with attic and crawlspace repairs taking longer due to working conditions.
Frequently Asked Questions, Condensate Drain Repair
AC Water Leak or Drain Backup?
Don't wait on water damage. We respond same-day for drainage emergencies.